Behind The Scenes of the 'New Generation'
June 1999
Chester Peterson Jr.
 |
Behind The Scenes of the "New Generation" tractor
|
When the John Deere Company introduced 'The New Generation' tractors on Aug. 30, 1960, in Dallas, Texas, it was a groundbreaking event. Why? Because the New Generation tractors didn't exhibit the usual 'evolutionary' modifications of new models. Instead, these were truly 'revolutionary' tractors.
RELATED CONTENT
Moline Tractor & Plow Company opens in Moline...
Unique John Deere All-Wheel-Drive tractor finally returns home...
JD field guide lives up to its name...
The story behind that revolution is detailed in 'John Deere New Generation Tractors.' Coauthor Rod Beemer and I found tracing the history of these great tractors both interesting and exciting.
In essence, what these tractors did for the tractor manufacturing industry was similar to raising the high jump bar to 10 feet. Here are some things we learned:
The decision to replace the venerable two-cylinder tractors was made in 1953. Secrecy equaled only by development of the atomic bomb in WW II prevailed for seven years.
Now, seven years may seem like a long time, but to develop an entirely new line of tractors, it was one heckuva feat.
A remote, empty Waterloo, Iowa, supermarket housed the initial development work. It wasknown to engineers selected for the project as the 'meat market.' Entrance was on a need-to-know basis, and even some high-level executives were turned away at the door.
A critically important element: determining and fixing of the center line dimensions of the block. A miscue and it would have been a $70 million mistake in today's dollars, not to mention loss of months of valuable time.
How good a job did the New Generation engineers do? Deere & Company is still using those same fixed-center dimensions in today's tractor engines.
Gear design was time consuming in those days before computerization. Even an engineer strong in math might require eight hours to do the calculations to eight decimal places.
One New Generation engineer decided that, after working all day, he'd drive three hours to spend his nights at the Moline, 111., headquarters trying to see if a computer could be harnessed for this precise work.
He was right: it could, and in only 15 minutes. So, the first computer program ever written for gear design was a result of the New Generation push.
An early model located a PTO control lever near the console at the left side. The lever was slightly curved at the top to let the driver's hand clear the console.
All was fine until a company executive dismounted from the left side, hooked his suit coat over the protruding PTO lever, and vented the jacket clear to the collar. The engineers followed his 'suggestion' to move the lever.
Page: 1 |
2 |
3 |
Next >>